Key Features

• This is a complete remote which will need to be programmed
• Instructions supplied on programming remote below for you
• Suitable for Ford Falcon Series 2 & 3 only
• Basically if your current remote looks the same it will work

Program Instructions:

• Sit in the car with the doors closed
• Turn the ignition to the ACC postition and within 5 seconds press the rear demist button 3 times (Note this bit must be done all within 5 seconds from when key turn)
• You then press a button on the first remote to be trained, the door locks will cycle
• Then press a button on the 2nd to be trained and the door locks will cycle again
• Repeat this step for the the rest of the remotes to be trained to the car
• The first keypad trained will result in one door lock cycle, the second will result in 2 door lock cycles, and so on
• There is a limit of 8 remotes per car
• Turn the ignition to the OFF position to exit the learning mode
• Your remotes are now programmed to your car
• Now if doesnt still work try same procedure again though this time lock doors before starting